Specification

Pre-installation
9
Note: Rated power is the average power that under the conditions of ambient temperature of 73.4℉±3.6℉, inlet
static pressure of 30psi ± 3psi, inlet water temperature of 41℉±0.9℉, turn on the rear wash function and set the
water flow, seat temperature and water temperature to the highest level successively, and press Stop button then
start rear wash function immediately and continue to work steadily for one cleaning cycle.
120V~
60Hz
1000W
32℉~104℉
≥25L/min
37.4℉~95℉
IPX4
Water supply temp. ~105.8℉
1000W
Room temp.~105.8℉
60W
Room temp.~140℉
≥4m/s
250W
(700X390X485)mm
Rear washing
Night light
Remote controller
Rated voltage
Rated frequency
Rated power
Ambient temp.
Pressure of Water supply
30psi~80psi(Static pressure)
Flow of Water supply
Temp of Water supply
Water proof rate
Water temp.
Water heating power
Seat temp.
Seat heater power
Ordinary dry temp
Maximum wind speed
Steam air heater power
Product size
Nozzle manual cleansing
Nozzle ultraviolet light
sterilization
Nozzle self cleansing
Antibacterial nozzle
Seat sensor
Soft close
Seat temp. adj.
Dry temp. adj.
Warm dry
Cleans-
ing
Flush
Single flush
Auto flush
Pre-wetting
Front washing
Auto washing
Oscillating
Fresh air
Cleans-
ing
Technical specifications
Seat and
Cover
Water pressure adj.
Water temp. adj.
Nozzle position adj.
5 level
5 level+Off
5 level+Room temp.
3 level+Room temp.
5 level
Above technical specification is obtained from the product which was tested in lab according to executive standard.
Executive standard:UL1431-2012 /UL1951/ASME A112.19.2-2018 CSA B45.1-18
Foot sensor detection to
flush