Installation Guide

Cautions
1. The water pressure limit is from 0.07 to 0.8 MPa (10 to116 PSI ). Please use as instructed.
2. The water shutoff valve should be near where the product can be installed and dismantled.
Please make sure you read the instructions carefully and install it properly.
Product Installation Procedure
Pre-installation
Installation Procedure
First installation method (recommended):
1.Dismantle the old seat and seat lid.
Loose the hinge and remove the old seat
and seat lid.
Keep the side with FRONT up
Installation
template
*Nut is supposed to be used for
the second method.
Installation template
Installation template
Second installation method
1. Refer to first installation method step 1 and 3. Dismantle the old seat and lid. Put the installation
template on the ceramic.
2. Refer to fist installation method step 4. Take the adaptable panel to the holes of the ceramic. Adjust
positionof the connecting bolts with adjusting pieces. Screw in the nuts form underside of the ceramic.
Then fix theadaptable panel.
3. Refer to first installation method step 5 and 6. Complete following installation procedure.
Seat and seat lid
2.Install expansive nuts
As figure, insert expansive nuts in the holes
of theceramic.
3.Install installation template 4.Fix the adaptable panel
As figure, take the adaptable panel to the holes
of the ceramic.Adjust position for connecting
bolts and adjusting pieces, make the
connecting bolts aim at according expansive
nuts. Then fix the adaptable panel.
5.Take away the installation template 6.Install the product
Keep the fix slots under the product aim at
slots on the adaptable panel. Push the product
to the end as figure below.Then completes
installation.
The fix slots under
the product
1.Insert the connecting bolts in adjusting pieces.
As figure,insert the connecting bolts in the boles of adjusting pieces.
2.Insert connecting bolts with adjusting pieces in the adaptable panel.
As figure,insert the connecting bolts in the boles of adjusting pieces in the holes
of the adaptable panel.
As figure, install the installation template on
the ceramic.