Instructions / Assembly

1.Clean the outside parts of the product.
2.Clean the nozzle
Pull out the nozzle softly and use smooth
cloth/sponge or toothbrush with kitchen
detergent to clean the nozzle.
Close the lid. Push the dismantlement button
and pull out the product as the arrow the
figure. Then the product will be dismantled.
4. Remove the main body.
Use a smooth sponge/cloth with diluted
kitchen detergent to clean the product.Do not
use the following types: hydrogen chloride
detergemt,paining thinner, benzene, abrasive
paper, polishing agent, fragrance and
insecticide, etc.
Insecticide
Abrasive paper
Paining thinner
Dismantlement button
Filter
Braided hoses
Product maintenance
5
As per figure A, rotate the lever to the highest
wash volume.
As per figure B,Remove the old lever along
the axis direction.
As per figure C, insert the new lever rib into
the corresponding control valve slot. The
installation is completed with a “click” sound.
As per figure A, Pull out the tube and do not
release then remove the old nozzle along the
axis direction.As per figure B, insert the new
nozzle into the tube along the corresponding
slot. The nozzle replacement is completed.
If water leaks from the two ends of water
hose, re-tighten the nuts to avoid water
leaking.
Rotate the lever in the working position, clip
out the regulator from the inlet tube by pliers.
Press the new regulator into the bottom of
the inlet tube. The regulator replacement is
completed. Then rotate the lever back to
non-working position.
Regulator
1. Lever replacement 2.Nozzle replacement
3. Regulator replacement 4. Water hose leaking solution
(If the water flow is smaller than usual)
1、Clean the filter for both sides. Make sure
to disconnect the water supply hose during
cleaning.
2、Clean the regulator o-ring (See the step 2
on the page 5 to find how to remove and
install theregulator o-ring).
Regulator
3.Clean the filter and regulator
A
B
nozzle
A
B
C