Instructions / Assembly

ManualsBrandsCasta Diva ManualsBathNon- Electric Bidet Seat for Elongated Toilet in White

1. Close the water valve and detach water pipe from the water tank.

Connect the t-shaped connector to the water tank.

Make sure that rubber packing is inserted in between.

3. Press the filter and washer at the two ends

of water hose into the screw tube, then

connect the main body and T-shaped

connector with water hose.

Washer

Filter

Connecting water hose

Prohibition

1.Do not lift the product with the seat cover and seat open.

2.Warning: The water supply can't be above 40 degrees or

below 0 degree.

This may cause a mechanical trouble.

4. Open the water valve to check if there is

any leakage.

Note: Please remove the regulator cover and regulate o-ring under the following conditions:

Caution: Must use the regulator cover and regulate o-ring when the water

pressure is bigger than 0.1MPa.

3、Insert the regulator component into the inlet pipe.

2、Remove the regulator cover and regulate o-ring except the

sealing o-ring.

1、Take out the regulator with pliers and other tools.

b.When the nozzle cannot work normally and water is low.

a.When the water dynamic pressure is lower than 0.05MPa, especially using the family tank.

2.Connect the water pipe to the t-shaped connector.

Regulator

cover

Regulate o-ring

Sealing o-ring

Off and Self-cleaning（Self-cleaning is an optional feature）

Keep the lever at the 90˚ position when not in use.

Position the lever at 25° before each use

then hold few second ,it could clean the

wand and once product connect warm

water could empty the cold water.

The wand cleans itself after each use.

For additional flush clean of the wand,

position the lever at 25˚ for a few

seconds and then reposition back to 90˚ .

WASH

Turn the lever clockwise from

the vertical position.

Nozzle for WASH moves forward

and start the function.

The water volume changes with

the turning of lever.

Low flow

High flow

Turn the lever anticlockwise from