MODLE: FB104/FB105/FB106 FB107/FB108/FB109 FB104 FB105 1 2 FB106 FB107 3 4 FB108 5 6 Product Maintenance 9 9 9 FB109
1.Main body 2.Installation template Water inlet on the left Dismantlement button Water inlet on the right 3.Fixing Components Seat cover Connecting bolts(2) Expansive nuts(2) or Water tanks Adaptable panel(1) Sliding plates(2) Lever Nut(2) Seat Water supply hose Bidet nozzle Wash nozzle 4.T-shaped connector 5.Water hose T-shaped connector Shutoff valve 6.Installation and User Manual Installation and User Manual Bowl Filter Water inlet hose Note: There are two methods for installation.
Installation Procedure First installation method (recommended): Please make sure you read the instructions carefully and install it properly. Cautions 1.Dismantle the old seat and seat lid. Loose the hinge and remove the old seat and seat lid. 2.Install expansive nuts As figure, insert expansive nuts in the holes of theceramic. 1. The water pressure limit is from 0.07 to 0.8 MPa (10 to116 PSI ). Please use as instructed. 2.
Connecting water hose 1. Close the water valve and detach water pipe from the water tank. Connect the t-shaped connector to the water tank. Make sure that rubber packing is inserted in between. WASH Turn the lever clockwise from the vertical position. Nozzle for WASH moves forward and start the function. The water volume changes with the turning of lever. Low flow High flow 2.Connect the water pipe to the t-shaped connector.
Product maintenance 1.Clean the outside parts of the product. 2.Clean the nozzle 1. Lever replacement Use a smooth sponge/cloth with diluted kitchen detergent to clean the product.Do not use the following types: hydrogen chloride detergemt,paining thinner, benzene, abrasive paper, polishing agent, fragrance and insecticide, etc. Pull out the nozzle softly and use smooth cloth/sponge or toothbrush with kitchen detergent to clean the nozzle. As per figure A, rotate the lever to the highest wash volume.
Self Diagnosis and Trouble shooting Status Cause Water is too low during WASH/BIDET No water comes out during WASH/BIDET Solution 1. Low water pressure of the unit During WASH/BIDET, turn the lever fast to biggest volume 2. Low water pressure of water supply When water supply pressure is lower than 0.7kgf/cm , contact local department for water pressure question 1. Water shut-off valve is turned off Turn on the water shut-off valve 2.
