User manual

SmartGuard CS Client/Server User Manual
About This Manual
These manuals will explains how to use SMARTGUARD CS software. The software is used in a
compatible IBM PC to monitor and control the CASTLE controller.
Audience
We assume that you are familiar with CASTLE controller as well as your PC’s hardware. It
does not mean that you have full knowledge of the functions of CASTLE system, however you
should have CASTLE controller User/Technical Manual when you use this manual.
How to Use This Manual
The following paragraphs tell you where to find the information when you need it. It is
important that you read this section in order to use this manual to its full potential.
CHAPTER 1 – SMARTGUARD CS OVERVIEW
SMARTGUARD CS software overview and introduction.
CHAPTER 2 - INSTALLING SMARTGUARD CS
This section describes the hardware and software that you need to install
SMARTGUARD CS and how to install it.
CHAPTER 3 - BASICS FOR USING SMARTGUARD CS
For beginner you should read through this section before continuing.
CHAPTER 4 - STARTING SMARTGUARD CS
This section describes how to execute and exit SMARTGUARD CS application.
CHAPTER 5 - SYSTEM CONFIGURATION PROCEDURE
Basic steps on how to configure the SMARTGUARD CS Software.
CHAPTER 6 – SMARTGUARD CS SERVER MENU FUNCTIONS
Complete menu of SMARTGUARD CS Server Application
CHAPTER 7 – SMARTGUARD CS CLIENT MENU FUNCTIONS
Complete menu of SMARTGUARD CS Client Application
Cass Technology Sdn Bhd 5