Operation Manual

caso SlimLine 3400 58
17 Troubleshooting
This chapter provides you with important notices with regard to
operating the device. Observe the following notices to avoid
dangers and damages:
17.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the
manufacturer, may carry out any repairs on electrical
equipment.
► Improperly performed repairs can cause considerable
dangers for the user and damages to the device.
17.2 Fault indications
In the event of a fault, an error code will appear in the display; it
describes the cause of the fault.
Display Description
0 Standby
The appliance is in Standby mode.
E0 Hob is not working
The appliance must be sent to Customer Service for repair.
E1 Unsuitable Cooking Vessel
The appliance has not recognised a suitable cooking vessel.
Use a suitable cooking vessel.
E2/E6 Appliance overheating
Allow appliance to cool down. Switch appliance off and then
on again in order to acknowledge the error, and reset.
E3/E4 Voltage too high/too low
The supply voltage is not within the required range. Use
suitable socket.
E5 Open electric circuit
The appliance must be sent to Customer Service for repair.
Please note
► If error messages continue to be displayed after an extended
waiting period or after restarting the appliance, then it must be
sent to Customer Service to be examined.