Operation Manual

Caso Fomini Jet 24
play with the appliance. Cleaning and user maintenance shall not be made by
children unless they are older than 8 and supervised.
Please note
► Keep the appliance and its cord out of reach of children less than 8 years.
► Do not leave the device unsupervised when it is in operation.
► Only qualified electricians, who have been trained by the manufacturer, may carry
out any repairs that may be needed. Improperly performed repairs can cause
considerable dangers for the user.
► Only customer service departments authorized by the manufacturer may carry out
repairs on the device during the guarantee period, as otherwise the guarantee
entitlements will be null and void in the event of any subsequent damages.
► Defective components must always be replaced with original replacement parts.
Only such parts will guarantee that the safety requirements are fulfilled.
► Do not use other liquids than milk.
12.3 Danger of burns
DANGER
The heated milk in the milk frother and the interior of the jug can get very hot.
Observe the following safety instructions and be careful not to burn or scald yourself or
others:
► When the milk is heated, the interior of the jug gets very hot!
► Always check the temperature of the milk, before drinking it.
► When you are heating the milk, keep the lid closed.
12.4 Dangers due to electrical power
DANGER
Mortal danger due to electrical power!
Mortal danger exists when coming into contact with live wires or subassemblies!
Observe the following safety notices to avoid dangers due to electrical power:
► If the connection lead is damaged, you will need to have a special connection lead installed
by an authorized electrician.
► Do not operate this device if its power cable or plug is damaged, if it does not work properly
or if it is damaged or has been dropped. If the power cable is damaged, it will need to be
replaced by the manufacturer or his service agency or a similar qualified person, to avoid
any dangers.
► Do not open the housing on the device under any circumstances. There is a danger of an
electrical shock if live connections are touched and the electrical or mechanical structure
is altered. In addition, functional faults on the device can also occur.