User Manual

IN-13
Installing the Wall Mount Bracket
To connect an angled eyelet safety wire
3.
Secure the adjuster unit to the inner arm using three M4×10mm hex head screws.
Important!Important!Impor tant!
 As shown in the illustrations below, you need to determine the adjuster unit installation location
on the inner arm in accordance with your projector’s resolution (WXGA or XGA) and the desired
projection size.
M4×10mm hex head screws
M4×10mm hex head screws
Inner arm
Adjuster unit
WXGA: 2.03m (80") or larger projection size
XGA: 1.78m (70") or larger projection size
WXGA: 1.78m (70") or smaller projection size
XGA: 1.52m (60") or smaller projection size
Inner arm
Adjuster unit
Later, you will use an M4×10mm hex head
screw to attach the safety wire and adjuster
unit to the inner arm here (page IN-18).
Later, you will use an M4×10mm hex head
screw to attach the safety wire and adjuster unit
to the inner arm here (page IN-18).