User Manual

Installing the Wall Mount Bracket
IN-12
Note that the attachment procedure you should use depends on whether the eyelet of the included
safety wire is straight or angled. Check the eyelet on your safety wire to determine which installation
procedure you should use.
To connect a straight eyelet safety wire
3.
Secure the adjuster unit to the inner arm using four M4×8mm hex head screws.
Important!Important!Impor tant!
 As shown in the illustrations below, you need to determine the adjuster unit installation location
on the inner arm in accordance with your projector’s resolution (WXGA or XGA) and the desired
projection size.
M4×8mm hex head screws
M4×8mm hex head screws
Inner arm
Adjuster unit
WXGA: 2.03m (80") or larger projection size
XGA: 1.78m (70") or larger projection size
WXGA: 1.78m (70") or smaller projection size
XGA: 1.52m (60") or smaller projection size
Inner arm
Adjuster unit