User Manual

Mastering TRACKFORMER Operations
EN-16
To change the sample playback method
NOTE
• This function can be used while the pad type is
sample.
1. Enter the PAD ACTION mode.
2. Press the pad you want to configure.
3. Use the sequence step keys to select a
playback method.
Use the procedure below to change the initial default
slice length to a value from 1 step to 16 steps.
1. Enter the SLICE LENGTH mode.
A sequence step key will light to indicate the current
slice length.
2. Use the sequence step keys to change the
slice length.
Use the procedure below to adjust four equalizer
frequency bands (HIGH, HIGH MID, LOW MID,
LOW).
1. Enter the MASTER EQ mode.
2. Use the pads to raise or lower the four
frequency bands.
• Use the VALUE knob to make fine adjustments.
• You can select a frequency band by pressing a pad,
and then change the frequency to be adjusted by
moving the ASSIGNABLE fader.
■ Selectable Frequencies
Entering the METRONOME mode causes the
metronome to sound. To turn off the metronome, hold
down the FUNCTION selector button again as you
press sequence step key 15.
Settings
Display
Message
Sequence
Step Key
Status
Description
Gate 13, 14: Lit The sample is played
once until the end, as
long as the pad is kept
depressed. Releasing
the pad stops sample
playback.
Loop 13: Flashing Sample playback
repeats as long as the
pad is depressed.
One-Shot 14: Flashing Pressing the pad plays
back the sample once,
all the way through.
Changing the Initial Default
Slice Length
Using the Equalizer
Band Frequency
LOW 50Hz, 100Hz, 200Hz, 400Hz, 800Hz
LOW MID 100Hz, 250Hz, 630Hz, 1.3kHz, 4kHz
HIGH MID 250Hz, 630Hz, 1.3kHz, 4kHz, 8kHz
HIGH 6kHz, 8kHz, 10kHz, 13kHz, 16kHz
Using the Metronome
+12
+6
LOW LOW MID HIGH MID HIGH
0
−
−
12
Max
Min
Frequency bands