User Manual

Mastering TRACKFORMER Operations
EN-14
You can use this setting to fix the volume level when a
pad is tapped, or to change the volume level in
accordance with how strongly the pad is tapped.
1. Enter the VELOCITY mode.
2. Press a sequence step key to change the
velocity curve.
* Amount of volume change when the pad is pressed
increases in the following sequence (from least to
most): Linear, Curve 1, Curve 2, Curve 3.
You can specify a pad set volume level for each bank.
1. Enter the PAD VOLUME mode.
2. Use the pads to change the volume level of
each bank.
Setting values: 0 to 127
• To make fine adjustments press any one of the pads
in the bank you want to adjust. When the pad is
flashing, use the VALUE knob to adjust the volume
level.
Use the procedures in this section to specify how a
sound should be produced when a pad is tapped.
To configure a pad for repeat play
1. Enter the PAD ACTION mode.
2. Press the pad you want to configure.
3. Use the sequence step keys to select a
trigger timing.
• Each press of a sequence step key toggles its trigger
timing between enabled (flashing) and disabled (lit).
• When a pad is configured not to repeat, all sequence
step keys from 1 through 6 are lit.
* Each press of this type of sequence step key cycles
the setting in the following sequence: Enabled (On)
3 Enabled (Triplicate) 3 Disabled (Off).
Changing the Pad Velocity
Sequence
Step Key
Display Message Setting
1 127 (fixed)
2 Linear*
3 Curve 1*
4 Curve 2*
5 Curve 3*
12 20 (fixed)
13 40 (fixed)
14 60 (fixed)
15 80 (fixed)
16 100 (fixed)
Changing the Pad Set Volume
Level
Changing the Operation of a
Pad
Sequence
Step Key
Display Message Settings
1 1/32
2 1/16, 1/16T*
3 1/8, 1/8T*
4 1/4, 1/4T*
5 1/2, 1/2T*
6 1
127
96
48
0
Max
Min
Bank 1 Bank 2 Bank 4Bank 3
Volume level
,
,
,
,