User Manual

Mastering TRACKFORMER Operations
EN-13
Entering the MIDI Control Mode stops sequence
playback. A special application (Data Editor) can be
used to configure assignments of pads, control buttons,
etc. from your computer. For information about Data
Editor, see “Saving and Loading TRACKFORMER
Data to a Computer and Editing TRACKFORMER Data
on a Computer” (page EN-23).
Patterns can be combined to create a sequence up to 16
measures long. Pressing the PLAY selector button
plays a sequence in accordance with the configuration
of the pattern created here. TRACKFORMER supports
creation of up to four pattern combinations (pattern
groups).
1. Press the PATTERN selector button.
2. Use the sequence step keys to select the
number of the pattern group you want to edit.
3. Enter the PATTERN EDIT mode.
4. Use the VALUE knob to change the number
of measures.
Setting values: 1 to 16 measures
5. After pressing pad 1, press the sequence
step key that corresponds to the number of
the pattern you want to use as measure 1.
This assigns the pattern to measure 1.
6. Repeat step 5 to assign patterns to the
remaining measures.
Entering the MIDI Control
Mode
Sequence step keys Navigates between pages 1 to 16.
Changing to a different page
changes the MIDI message output
when a pad is pressed.
• The sequence step key that
corresponds to the currently
selected page flashes.
Pads,
FX1 and FX2 knobs,
ASSIGNABLE fader
Outputs MIDI messages assigned by
the MIDI map. MIDI map
assignments are configured with
Data Editor.
PLAY button Outputs play and pause MIDI
messages.
Changing the Configuration of
a Pattern
1
2
2
2
1
2
3
4
4
6
6
6
3
8
8
8
4
7
7
7
1
5
5
5
4
4
4
4
3
3
3
3
...
...
...
...
Pattern group numbers Patterns
Pattern group 4
Pattern group 3
Pattern group 2
Pattern group 1
2
1
Patterns
1 to 8
Measures
1 to 16