User Manual

Mastering TRACKFORMER Operations
EN-12
Use the procedures in this section to change the pitch
of a sequence when all pad tones are note.
1. Enter the KEY SHIFT mode.
• You can check the current setting with the pad and
screen.
2. Use the pads to change the pitch.
Setting values: –7 (Pad 1) to 0 (Pad 8) to +8 (Pad 16)
• You can also use the VALUE knob to change the
setting. With the VALUE knob, the setting range is
–24 to +24.
NOTE
• You can change the pitch of each pattern in a pattern
group (page EN-13). Select a pattern group and play
back its sequence. While the pattern whose pitch you
want to change is playing, perform the above steps
to change it.
1. Enter the MAX STEP mode.
This will cause the sequence step key that corresponds
to the number of steps to flash.
2. Press the sequence step key that
corresponds to the number of steps you want
to specify.
Setting values: 1 to 16 steps
• You can also use the VALUE knob to change the
setting.
NOTE
• You can specify the number of steps setting for each
pattern group (page EN-13). Select a pattern group
and then perform the steps above to change the
number of steps.
1. Enter the SWING mode.
2. Use the pads to change the swing value.
Each pad changes the value as shown below.
• You can also use the VALUE knob to change the
setting. With the VALUE knob, the setting range is 0
to 100.
NOTE
• You can specify the swing value for each pattern
group (page EN-13). Select a pattern group and then
perform the steps above to change the swing value.
Changing the Pitch of a
Sequence
Pattern configuration:
Pitch: +0 +2 +0 –2 –4
14341
Changing the Number of Steps
Per Measure
Applying a Swing Effect
70 74 78 82
54 58 62 66
38 42 46 50
22 26 30 34