User Manual

• IP address Specifies the controller IP address.

• IP ID Specifies the controller IP ID.

• Port Specifies the number of the port being used. (Always 41794)

Enter the applicable information for each item and then click the [Apply] button. This will restart

the network function and apply the new settings.

AMX

This Projector supports the AMX controller and Device Discovery. Commands used for control are

PJLink standard commands.

For detailed information, visit the website below.

URL: http://www.amx.com/

Extron

This Projector supports the Extron controller. Commands used for control are PJLink standard

commands.

For detailed information, visit the website below.

URL: http://www.extron.com/

Caution

• The Projector can be configured to enable or disable power via wired LAN on from the

standby state. To do so, use [Network Settings]-[Remote On] on the Projector's Setup Menu.

Enable: Power on enabled.

Disable: Power on disabled. (Initial default)

Initializing network settings or performing a "Restore All Defaults" operation with the Setup

Menu will cause this setting to change to "Disable". If you are operating the Projector using a

wired LAN setting, be sure to change this setting back to "Enable" after initialization.

• Depending on its model, some of the sources may not be supported by and may not be

available on your projector.