User Manual
Table Of Contents
- Contents
- Safety Precautions
- Operating Precautions
- Getting Ready
- Operating the Projector
- Basic Image and Audio Operations During Projection
- Digital Screen Shift
- Test Pattern Projection
- Changing the Audio Input
- Control Panel Lock
- Configuring Remote Control ID and Projector ID Settings
- Using the Presentation Timer (TIMER)
- Using the Setup Menu (MENU)
- Password Protection
- Projecting from USB Input (Network Models Only)
- Projecting the Screen Image of a Graphing Calculator
- Cleaning the Projector
- Troubleshooting
- Appendix
- Specifications
59
POS Setup Type*
6
0: Projection with top of projector upwards, screen in front
1: Projection with top of projector downwards, screen in back
2: Projection with top of projector upwards, screen in back
3: Projection with top of projector downwards, screen in front
APO Auto Power Off 0: Off, 1: 5 minutes, 2: 10 minutes, 3: 15 minutes, 4: 20 minutes
5: 30 minutes
STS Reads the projector
error status.
0: Normal, 1: Fan error, 2: Temperature error, 7: Light error
16: Other error
MIC Microphone Input Level 0 to 3
IDS Projector ID 0: All, 1: ID1, 2: ID2, 3: ID3, 4: ID4
*1 This setting is applied to the input source signal that is currently being projected by the projector.
*2 Setting 0 is the “Normal” setting when the input source is RGB or HDMI(PC), while setting 2 is the
“Normal” setting when the input source is component, HDMI(DTV), Video, or S-Video.
*3 Light Control Off Mode settings.
*4 The setting range on the projector setup menu is –60 to 60.
*5 Each KEY command setting corresponds to a remote controller key. The projector operation that is
performed in response to a KEY command is identical to the corresponding remote controller key
operation. When sending KEY commands to the projector from an external device, make sure they
are sent in the same sequence that the corresponding key operations are performed on the remote
controller.
*6 Specifies how the projector is set up relative to screen for projection. Corresponds to the projector
setup menu “Projection Mode” and “Ceiling Mount” commands.
Command
Name
Function Settings
R