User Manual

16
Getting Ready
As you unpack the projector, check to make sure that all of the items listed below are present.
 Projector
 Wireless remote controller YT-131 (XJ-UT311WN, XJ-UT351WN)
 Wireless remote controller YT-160 (XJ-UT331X, XJ-UT351W)
 Test Batteries (AAA-size × 2)
 AC Power Cord
 Cable cover
 “Safety Precautions” Sheet
 “Read this first” Sheet
 Warranty
 Wireless adapter YW-40 (XJ-UT311WN only)
This section explains the operational flow up to the point that projection is started.
1. Load the test batteries that come with the projector into the remote controller.
 Use only alkaline batteries to power the remote controller.
2. Place the projector onto a table, desk, or stand that is level and firm, making
sure that you allow enough room around it.
 “Safety Precautions” (page 6), “Operating Precautions” (page 12)
 “Setting Up the Projector” (page 19), “Setup Precautions” (page 19)
You will need to purchase special hardware to mount this projector on a wall. For details, contact
the retailer where you purchased the projector.
3. Adjust the vertical angle of the projector.
 “To adjust the vertical angle of the projector” (page 19)
4. Use the supplied power cord to plug the projector into a power outlet.
5. Connect the projector to an image output device and/or audio output device, and
then turn on each device.
 “Connecting with an External Device” (page 20)
Unpacking
Operation Flow to Projection