User Manual

25
Network Settings Page Items
To do this: Perform this operation:
Specify auto acquisition of an IP
address from the external LAN
device
In the “IP Settings” area, click “Obtain an IP address automatically”.
Specify the IP address manually 1. In the “IP Settings” area, click “Use the IP address below”.
2. In the “IP Address” boxes, enter the IP address you want to assign to the
projector (Initial Default: 192.168.100.10).
3. In the “Subnet Mask” boxes, enter a value that will be used to determine
range of IP addresses of the network (subnet) to which the projector will
belong (Initial Default: 255.255.255.0).
4. In the “Default Gateway” boxes, input the IP address of the default
gateway (Initial Default: 192.168.100.10).
Specify auto allocation of IP
addresses to computers and smart
devices by the projector
1. In the “DHCP Settings” area, click “Auto”.
2. Specify the range of automatically allocated IP addresses as required.
 In “Starting Address” and “Ending Address”, input a value in the range
of 11 to 254 for the fourth octet.
 Only the fourth octet can be specified by you. The other octets cannot
be changed.
Specify no allocation of IP addresses
to computers and smart devices by
the projector
In the “DHCP Settings” area, click “Disable”.
Enable wireless LAN connection to
the projector from a computer and/or
smart device (by enabling the built-in
access point function)
Change the “Wireless Settings” area “Access Point Function” setting to
“Enable”.
Disable wireless LAN connection to
the projector from a computer and/or
smart device (by disabling the built-in
access point function)
Change the “Wireless Settings” area “Access Point Function” setting to
“Disable”.
Enable/disable SSID broadcasting In the “Wireless Settings” area, select “Enable” or “Disable” for “SSID
Broadcast”.
Specify the channel for wireless LAN
communication
In the “Wireless Settings” area, click [] on the right side of the “Channel”
box. On the list that appears, select a channel from 1 to 11.
Specify auto selection of the wireless
LAN channel to be used
In the “Wireless Settings” area, click [] on the right side of the “Channel”
box. On the list that appears, select “Auto”.
Connect the projector to an external
wireless access point
In the “External Access Point” area, click “Enable” and configure settings
as required.
For details, see “To connect the projector to a wireless LAN access point
without terminating a direct wireless LAN connection with a computer”
(page 10).
Do not connect the projector to an
external wireless access point
In the “External Access Point” area, click “Disable”.