User Manual

24
Control Panel Page Network Items
To do this: Perform this operation:
Change the projector name In the “Projector name” box, input up to 16 single-byte
characters (no symbols) for the projector name.
Specify whether or not to require log in code input
when establishing a wireless LAN connection
In the “Login Code” area, click “ON” (prompt for login code
input) or “OFF” (do not prompt for login code input).
Specify whether to show or hide the user name of the
computer currently projecting on the projector via a
wired LAN
In the “Show User Name” area, click either “ON” (show) or
“OFF” (hide).
Specify whether projector power can be turned on
via LAN while the projector is in standby
In the “Remote On*
1
” area, click “Enable” (enable power
on) or “Disable”.
Enable or disable PJLink connection authentication In the “PJLink Authentication” area, click “Enable” or
“Disable”.
Enable or disable wireless LAN standard
IEEE802.11n
In the “IEEE 802.11n (Wi-Fi)” area, click either “Enable” or
“Disable”.
Specify whether wireless LAN channel width should
be set automatically or should be fixed (20 MHz)
In the “Channel Width” area, click “20MHz” or “Auto”.
*1 Projector standby power consumption depends on whether or not “Remote On” is enabled. For
information about power consumption in each standby state, see the “User’s Guide”.