User Manual

19
Change the SSID
Important!
 If a user SSID has already been created, you will not be able to change the
SSID using the projector menu.
1. Press the [MENU] key and then select the following: “Network Settings” 3
“Projector Wireless LAN Settings” 3 “SSID”.
2. Press the [ENTER] key.
 This displays a list of selectable SSIDs.
3. Use the [] and [] keys to select the SSID you want and then press the [ENTER]
key.
4. Use the [ESC] key to return to “Network Settings”.
5. Use the [] key to select “Update Network Settings” and then press the [ENTER]
key.
6. On the confirmation dialog box that appears, press the [] key to select “Yes”,
and then press the [ENTER] key.
Change the IP settings 1. Press the [MENU] key and then select the following: “Network Settings” 3
“Projector Wired LAN Settings” or “Network Settings” 3 “Projector Wireless LAN
Settings” 3 “IP Settings”.
2. On the “IP Settings” dialog box that appears, configure the settings below.
 To specify auto acquisition of an IP address, select “Auto” for “IP Settings”.
 To specify the IP address manually, specify “Manual” for “IP Settings” and
input an IP address manually (see below).
(1) Use the [] key to select “IP Address” and then press the [ENTER] key.
 This displays the “Input IP Address” dialog box.
(2) Use the [] and [] keys to specify the first octet (three digits) of the IP
address. After the setting is the way you want press the [] key.
(3) Repeat step (2) to specify octets two through four.
 A value within the following ranges can be specified for each octet: 1st: 1
to 223; 2nd: 0 to 255; 3rd: 0 to 255; 4th: 1 to 254.
(4) When the IP address is the one you want, press the [ESC] key.
3. Use the [ESC] key to return to “Network Settings”.
4. Use the [] key to select “Update Network Settings” and then press the [ENTER]
key.
5. On the confirmation dialog box that appears, press the [] key to select “Yes”,
and then press the [ENTER] key.
Initialize network settings 1. Press the [MENU] key and then select the following: “Network Settings” 3
“Initialize Network Settings”.
2. Press the [ENTER] key.
3. On the confirmation dialog box that appears, press the [] key to select “Yes”,
and then press the [ENTER] key.
To do this: Perform this operation: