User Manual

16
1. Connect the computer to the projector with the LAN cable (use of a shielded LAN
cable (STP) is recommended).
Projector Operation
2. Press the [INPUT] key. This will display the “Input” dialog box.
3. Use the [] and [] keys to select “Network” and then press the [ENTER] key.
4. Check the IP address (“Server IP”) in the lower left corner of the LAN connection
standby screen.
 Here, we will use a projector IP address of 192.168.100.10 (projector initial default setting).
Computer Operation
5. Check to make sure that settings are configured for automatic acquisition of the
computer’s IP address.
 If you want to specify the IP address of the computer manually, change it to 192.168.100.XXX
(XXX is a value from 1 to 9 or 11 to 254).
 The steps up to this point are to establish a LAN connection between the projector and
computer. The steps from here are for projecting the computer screen.
6. Start up Network Connection.
 If the “Set Network Location” dialog box appears, click [Cancel] to close the dialog box.
 The Network Connection window will appear with the message “Connecting”.
7. On the “Enter the login code.” dialog box that appears, input the required login
code.
 In the “Login Code” box, input the four-digit number shown in the upper left corner of the LAN
connection standby screen that is being projected.
8. When everything is the way you want, click [OK].
 This will cause the Network Connection window to change as shown below, and projection of
the computer screen image (main window) will start.
 For details about Network Connection window operations, see the separate “Network
Connection Guide”.
Note
 When using the above type of connection, settings can be configured to eliminate the need for
login code input. For information about how to configure such settings see “Configure Control
Panel page network settings” (page 22).
Using a LAN Cable to Connect a Computer Directly to the
Projector