User Manual

14
The procedure below assumes the conditions described below.
 The computer is already connected to the wireless LAN access point.
It makes no difference whether the computer is connected by wireless LAN (Wi-Fi) or wired LAN
(using a LAN cable). If the computer is connected by wired LAN connection, make sure the
computer’s wireless LAN function is disabled.
 Projector settings have already been configured using the procedure under “Connecting the
Projector to a Wireless LAN Access Point” above, and wireless LAN access point and/or projector
settings have not been changed since then.
 The projector is within range supported by the wireless LAN access point.
Projector Operation
1. Connect the wireless adapter to the projector (page 6) and then turn on the
projector.
2. Press the projector’s [INPUT] key as many times as necessary to select
“Network”, and then press the [ENTER] key.
 The input source will switch to “Network”, and projection of the LAN connection standby
screen will start.
Computer Operation
3. Start up Network Connection.
 If the “Set Network Location” dialog box appears, click [Cancel] to close the dialog box.
 The Network Connection window will appear with the message “Connecting”.
 If multiple connectable projectors are found, a “Projector List” dialog box will appear. If this
happens, click the IP address of the projector you want to connect to, and then click [OK]. For
the projector’s IP address, check “Server IP” in the lower left corner of the projection screen
(LAN connection standby screen).
4. On the “Enter the login code.” dialog box that appears, enter the login code and
then click [OK].
 In the “Login Code” box, enter the four-digit number shown in the upper left corner of the LAN
connection standby screen that is being projected.
 While the projector is connected to a computer over a wireless LAN, a Network Connection
window like the one shown below will be displayed on the computer screen. The computer
screen image (main screen) will be projected.
 For details about Network Connection window operations, see the separate “Network
Connection Guide”.
Note
 Settings can be configured to eliminate the need for login code input. For information about
how to configure settings, see “Configure Control Panel page network settings” (page 22).
Establishing a Connection between the Projector and
Computer and Projecting via a Wireless LAN Access Point