User manual - Basic_43W_E

Getting Ready

E-14

You can change the elevation angle of the projector in a range of 0 to 12 degrees. You can

also make fine adjustments to the left and right side elevation angle when necessary.

To change the projector elevation angle

1. Lift up the front of the projector and press

the release button

z This causes the elevation adjustment foot 2

to drop from the bottom of the projector.

z Be sure to press the release button before

trying to lower the elevation adjustment foot.

Pulling on the foot without pressing the

release button can damage the foot.

2. While holding down the release button, raise

and lower the front of the projector until the

elevation adjustment foot is approximately the

length you need.

3. Release the release button to lock the elevation adjustment foot in its current position.

4. Use the left and right adjustment feet 3 to further fine adjust the elevation angle.

z The left and right adjustment feet are for fine adjustment only. Do not try to rotate them

too far. Doing so can cause an adjustment foot to detach. Tightening an adjustment foot

too strongly can cause it to become stuck.

z To retract the elevation adjustment foot, hold down the release button and slide the

elevation adjustment foot back into the projector. Never try to forcibly change the elevation

adjustment foot position without pressing the release button.

Adjusting the Projector Elevation Angle