User manual - Basic_43W_E

E-12
Getting Ready
Locate the projector on a desk, table, or stand that is firm and level. Make sure to allow
sufficient space around the sides and back of the projector for proper ventilation.
z The following illustrations show how the projector should be oriented for optimum projection
relative to the screen.
z You can place the projector on a surface that is angled up to 30 degrees upwards or
downwards during use. Never locate the projector on a surface that is angled more than 30
degrees, or angled at all to the left or right. Such conditions can cause the lamp to
explode or can shorten lamp life, and also creates the risk of malfunction.
z The projector’s auto keystone correction range is 0 to +30 degrees. If the surface you are
projecting onto is angled downwards from horizontal, use manual keystone correction (page
E-20) to correct the image.
z Turn on the “High Altitude” setting on the setup menu when using the projector in a high
altitude (1,500 to 3,000 meters (5,000 to 10,000 feet) above sea level) area where air is
thin. For details, see the User’s Guide on the CD-ROM that comes with the projector.
z The projector can be configured for projection from the back of a screen. For details, see
the User’s Guide on the CD-ROM that comes with the projector.
Setting Up the Projector
Viewed from Above Viewed from the Side
The center of the
projector’s lens
should be aligned
with the horizontal
center of the screen.
Screen Screen
Position the
projector so the
lens side is at the
edge of the table,
etc.