User Manual

5
Caution
• The Projector can be configured to enable or disable power via wired LAN on from the standby
state. To do so, use [Network Settings]-[Remote On] on the Projector's Setup Menu.
Enable: Power on enabled.
Disable: Power on disabled. (Initial default)
Initializing network settings operation with the Setup Menu will cause this setting to change to
"Disabled". If you are operating the Projector using a wired LAN setting, be sure to change this
setting back to "Enabled" after initialization.
• The Projector has the following restrictions when it is turned on from the standby state.
・ The wired LAN connection will be disconnected for about one minute after the projector is
turned on.
Therefore, during this time, even if you send a ping command, no reply is returned from the
projector, and you cannot operate the projector using the PJLink / Crestron / AMX command.
・ When you get an IP address from a DHCP server automatically, some DHCP servers do not
always assign the same IP address. A different IP address may be assigned.
If you do not want a different IP address to be assigned, change a setting to use a fixed IP
address.