User Manual
Table Of Contents
- Contents
- Safety Precautions
- Operating Precautions
- Getting Ready
- Unpacking
- Operation Flow to Projection
- General Guide
- Key and Indicator Panel
- Back Terminals
- Placing the Projector on a Desk or on the Floor
- Connecting with Another Device
- Connecting a Computer
- Connecting to a Video Device
- Outputting Audio from the Projector to Another Device
- Connecting a Microphone (XJ-UT Series, XJ-F21XN, XJ-F211WN, XJ-S400UN, XJ-S400WN)
- Connecting to a Network with a LAN Cable (Network Models Only)
- Connecting a Wireless Adapter (Network Models Only)
- LOGO Terminal (Firmware Updates, User Logo Transfers)
- Connecting a Scientific Calculator (Network Models Only)
- SERIAL Terminal (Projector Control Using Commands)
- USB Power
- Cover Included with the YW-41 Wireless Adapter
- Attaching and Removing the Cable Cover (XJ-UT Series)
- Remote Controller
- Operating the Projector
- Turning the Projector On or Off
- Selecting an Input Source (INPUT)
- Using Auto Projection Off
- Basic Image and Audio Operations During Projection
- Flipping the Projected Image Horizontally (Mirror Mode)
- Light Control
- Digital Screen Shift
- Projecting a Template
- Test Pattern Projection
- Control Panel Lock
- Configuring Remote Control ID and Projector ID Settings
- Using the Countdown Timer (TIMER)
- Using the Presentation Timer (TIMER)
- Using the Setup Menu (MENU)
- Using a Password
- Cleaning the Projector
- Troubleshooting
- Appendix
- Supplying USB Power to Another Device
- Mounting the Projector on a Wall (XJ-UT Series)
- Hanging the Projector from a Ceiling
- Using the MONITOR OUT Terminal (XJ-UT Series, XJ-S400UN, XJ-S400WN)
- Projection Distance and Screen Size
- Aspect Ratio Setting and Projection Image
- Supported Signals
- Projector RS-232C Control
- Specifications
41
Operating the Projector
Unless specifically noted otherwise, the operations in this section are performed using the remote
controller. If both the projector and the remote controller have the same key, either one can be used to
perform the corresponding operation.
This section explains how to turn projector power on and off, and provides information about power-
related settings.
For information about the general procedure that is required before turning on the projector, see
“Operation Flow to Projection” (page 21).
To turn on the projector
1.
Connect the provided power cord to the projector’s AC terminal and plug in to a
power outlet.
Wait until the POWER/STANDBY indicator lights red.
2.
Press the [P] key to turn on the projector.
This will cause the POWER/STANDBY indicator (green) to flash for a few seconds, and then
stop flashing and remain lit.
The projector will perform an auto input search operation at this time. If it finds an input signal,
it will start projecting its image. For details, see “Using Auto Input Search” (page 43).
Note
For details about what indicators show, see “Normal Operation Indicators” (page 70).
To turn off the projector
1.
Press the [P] key.
This will cause the POWER/STANDBY indicator (red) to flash for a few seconds, and then stop
flashing and remain lit.
2.
Unplug the power cord from the power outlet and then disconnect it from the
projector.
Direct Power On
When “On” is selected for the “Option Settings 1 3 Direct Power On” setting (page 64), the projector
will turn on automatically whenever you plug its power cord into a power outlet. (Initial default setting:
“Off”).
Turning the Projector On or Off