User Manual

39
Before attaching or removing the cable cover, turn off the projector and unplug its power plug from the
power outlet. After turning off the projector, wait for a while to allow it to cool.
Attaching and Removing the Cable Cover
(XJ-UT Series)
To attach the cable cover
1. Turn the projector over and insert
the cable cover hook into the hole
provided on the projector (Figure 1).
2. Rotate the cable cover in the
direction indicated by the arrow in
Figure 2 to attach it to the projector.
3. Aligning the cable cover screw with
the screw hole on the projector
(Figure 3), use a Phillips head screw
driver to tighten the screw (Figure 4).
To remove the cable cover
1. Use a Phillips head screw driver to
loosen the cable cover screw until it
disengages from the projector
(without detaching it from the
cover).
2. Remove the screw side of the cable
cover from the projector and then
unhook the cover hook from the
projector.
Figure 1 Figure 2
Figure 3 Figure 4
Screw
Hook
Screw
Screw hole