User Manual
Table Of Contents
- Contents
- Safety Precautions
- Operating Precautions
- Getting Ready
- Unpacking
- Operation Flow to Projection
- General Guide
- Key and Indicator Panel
- Back Terminals
- Placing the Projector on a Desk or on the Floor
- Connecting with Another Device
- Connecting a Computer
- Connecting to a Video Device
- Outputting Audio from the Projector to Another Device
- Connecting a Microphone (XJ-UT Series, XJ-F21XN, XJ-F211WN, XJ-S400UN, XJ-S400WN)
- Connecting to a Network with a LAN Cable (Network Models Only)
- Connecting a Wireless Adapter (Network Models Only)
- LOGO Terminal (Firmware Updates, User Logo Transfers)
- Connecting a Scientific Calculator (Network Models Only)
- SERIAL Terminal (Projector Control Using Commands)
- USB Power
- Cover Included with the YW-41 Wireless Adapter
- Attaching and Removing the Cable Cover (XJ-UT Series)
- Remote Controller
- Operating the Projector
- Turning the Projector On or Off
- Selecting an Input Source (INPUT)
- Using Auto Projection Off
- Basic Image and Audio Operations During Projection
- Flipping the Projected Image Horizontally (Mirror Mode)
- Light Control
- Digital Screen Shift
- Projecting a Template
- Test Pattern Projection
- Control Panel Lock
- Configuring Remote Control ID and Projector ID Settings
- Using the Countdown Timer (TIMER)
- Using the Presentation Timer (TIMER)
- Using the Setup Menu (MENU)
- Using a Password
- Cleaning the Projector
- Troubleshooting
- Appendix
- Supplying USB Power to Another Device
- Mounting the Projector on a Wall (XJ-UT Series)
- Hanging the Projector from a Ceiling
- Using the MONITOR OUT Terminal (XJ-UT Series, XJ-S400UN, XJ-S400WN)
- Projection Distance and Screen Size
- Aspect Ratio Setting and Projection Image
- Supported Signals
- Projector RS-232C Control
- Specifications
37
After connecting a scientific calculator to the projector, you will be able to project the calculator’s
screen image. For information about connectable calculators, go to the CASIO website.
Important!
To project the screen image of a scientific calculator, select “CASIO USB Tool” as the
projector’s input source. For information about how to do this, see “Changing the Input
Source Manually” (page 45).
If you experience problems after connecting a scientific calculator to the projector, disconnect
the USB cable from both devices. Next, use the cable to re-connect them.
For information about scientific calculator operation, refer to its user documentation.
You can control the projector by sending it commands from a device (computer, other RS-232C
controller device) connected to the projector’s SERIAL terminal.
For details about control commands, see “Projector RS-232C Control” (page 85).
Connecting a Scientific Calculator (Network Models Only)
XJ-UT312WN, XJ-UT352WN XJ-F21XN, XJ-F211WN XJ-S400UN, XJ-S400WN
Projector Terminal Connection Cable Calculator Terminal
USB-A/DC 5V
or
USB-A
USB port
SERIAL Terminal (Projector Control Using Commands)
XJ-UT Series XJ-F Series XJ-S Series
Projector Terminal Connection Cable Other Device Terminal
SERIAL RS-232C terminal
USB cable
USB Type A Type B mini
SERIAL terminal
SERIAL terminal
SERIAL terminal
Serial cable (cross)
D-Sub9 pin