User Manual
Table Of Contents
- Contents
- Safety Precautions
- Operating Precautions
- Getting Ready
- Unpacking
- Operation Flow to Projection
- General Guide
- Key and Indicator Panel
- Back Terminals
- Placing the Projector on a Desk or on the Floor
- Connecting with Another Device
- Connecting a Computer
- Connecting to a Video Device
- Outputting Audio from the Projector to Another Device
- Connecting a Microphone (XJ-UT Series, XJ-F21XN, XJ-F211WN, XJ-S400UN, XJ-S400WN)
- Connecting to a Network with a LAN Cable (Network Models Only)
- Connecting a Wireless Adapter (Network Models Only)
- LOGO Terminal (Firmware Updates, User Logo Transfers)
- Connecting a Scientific Calculator (Network Models Only)
- SERIAL Terminal (Projector Control Using Commands)
- USB Power
- Cover Included with the YW-41 Wireless Adapter
- Attaching and Removing the Cable Cover (XJ-UT Series)
- Remote Controller
- Operating the Projector
- Turning the Projector On or Off
- Selecting an Input Source (INPUT)
- Using Auto Projection Off
- Basic Image and Audio Operations During Projection
- Flipping the Projected Image Horizontally (Mirror Mode)
- Light Control
- Digital Screen Shift
- Projecting a Template
- Test Pattern Projection
- Control Panel Lock
- Configuring Remote Control ID and Projector ID Settings
- Using the Countdown Timer (TIMER)
- Using the Presentation Timer (TIMER)
- Using the Setup Menu (MENU)
- Using a Password
- Cleaning the Projector
- Troubleshooting
- Appendix
- Supplying USB Power to Another Device
- Mounting the Projector on a Wall (XJ-UT Series)
- Hanging the Projector from a Ceiling
- Using the MONITOR OUT Terminal (XJ-UT Series, XJ-S400UN, XJ-S400WN)
- Projection Distance and Screen Size
- Aspect Ratio Setting and Projection Image
- Supported Signals
- Projector RS-232C Control
- Specifications
36
Connecting the projector’s wireless adapter* enables wireless connection to a computer or a smart
device, or to an existing wireless access point.
* The YW-41 wireless adapter may have been provided with your projector or may be available
separately. See “Unpacking” (page 21).
XJ-UT312WN, XJ-UT352WN, XJ-S400UN, XJ-S400WN
Plug into the
USB-A/DC 5V port or the
USB-A port.*
* If you have an XJ-S Series projector whose wireless adapter is covered
(page 38), connect the adapter to the
USB-A port.
XJ-F21XN, XJ-F211WN
Plug into the
USB-A/DC 5V port.
For details about operations to use for wireless connection of the projector to a computer or a wireless
access point, and about operations after a connection is established, refer to the separate “Network
Function Guide”.
You can update the projector’s firmware (software in the projector’s flash ROM) using a computer
connected to the projector’s LOGO terminal. You can also transfer user logo images from the
computer to the projector.
For information about operations after connection, refer to the documentation below, which is
available from the CASIO website.
Connecting a Wireless Adapter (Network Models Only)
XJ-UT312WN, XJ-UT352WN XJ-F21XN, XJ-F211WN XJ-S400UN, XJ-S400WN
LOGO Terminal (Firmware Updates, User Logo Transfers)
XJ-UT Series XJ-F Series XJ-S Series
Projector Terminal Connection Cable Computer Terminal
LOGO USB port
Firmware updates :Projector Firmware Update Guide
User logo transfers : User Logo Transfer Guide
LOGO terminal
LOGO terminal
LOGO terminal
USB cable
USB Micro B