User Manual
Table Of Contents
- Contents
- Establishing a Network Connection Between the Projector and a Computer
- Establishing a Direct Wireless LAN Connection Between a Computer and the Projector
- Using a Wired LAN Connection to Connect the Projector to an Existing Network
- Connecting the Projector to an Existing Wireless LAN Access Point
- Using the Projector as a NAT Router (Simultaneous Use of Wireless LAN and Wired LAN)
- Using the Remote Controller to Configure Projector Network Settings
- Using a Computer to Configure Projector Network Settings
- Preparing for C-Connection
- Network Projecting a Computer Screen Image (Using C-Connection)
- C-Connection Details
- Advanced Operations
- Controlling the Projector from an External Network Device
- Ports Used for TCP/UDP
58
Controlling the Projector from an External Network
Device
This projector supports the external devices and commands below.
For more information, visit the CASIO website below.
https://world.casio.com/download/projector/
Note
The authentication password used when connecting a PJLink device to the projector is the
projector’s Admin Password (page 30).
For information about the ports used by PJLink, see “Ports Used for TCP/UDP” (page 59).
External Devices and Commands Refer to:
All PJLink Class1 (Version 1.00) commands http://pjlink.jbmia.or.jp/english/
Crestron Electronics controller and software (RoomView
®
Express) commands https://www.crestron.com
AMX Device Discovery http://www.amx.com
B