User Manual
Table Of Contents
- Contents
- Establishing a Network Connection Between the Projector and a Computer
- Establishing a Direct Wireless LAN Connection Between a Computer and the Projector
- Using a Wired LAN Connection to Connect the Projector to an Existing Network
- Connecting the Projector to an Existing Wireless LAN Access Point
- Using the Projector as a NAT Router (Simultaneous Use of Wireless LAN and Wired LAN)
- Using the Remote Controller to Configure Projector Network Settings
- Using a Computer to Configure Projector Network Settings
- Preparing for C-Connection
- Network Projecting a Computer Screen Image (Using C-Connection)
- C-Connection Details
- Advanced Operations
- Controlling the Projector from an External Network Device
- Ports Used for TCP/UDP
22
To change the Web Service page password
Important!
When connecting the projector to a network, be sure to change the initial default passwords
below to passwords you want to use.
1.
Perform steps 1 through 3 under “To log into the Projector Setup page” (page
20).
2.
In the sidebar, click the following links in sequence: “System Settings” 3
“Change Passwords”.
This displays the Change Passwords page.
Perform both or either of the operations in step 3 to change the Admin Password and step 4 to
change the Moderator Password.
3.
Change the Admin Password.
Admin Password is the login password for the Projector Setup page (page 20). This password
also is used when logging into the projector from a PJLink device (page 58).
Each character you input is hidden, and indicated by a dot (
•
) in the input box.
(1) For “Admin Password”, input the current Admin Password into the “Old password” box.
The initial default Admin Password is: admin.
(2) Under “Admin Password”, input the new password into both the “New password” and
“Reinput Password” boxes.
A password must have at least five characters and can have up to 50 characters.
You can use any of the following types of characters: numerals, alpha characters (upper
case or lower case), or single-byte symbols (except \, ”, ’).
A password strength indicator below the input box shows the strength of the password
being input into “New password”.
4.
Change the Moderator Password.
The Moderator Password is the login password for the following function pages: Moderator
(page 49), Projector Remote (page 52), and Template Pattern Customization (page 54).
Each character you input is hidden, and indicated by a dot (
•
) in the input box.
(1) For “Moderator/Projector Remote/Template Password”, input the current Moderator
Password into the “Old password” box.
The initial default Moderator Password is: moderator.
(2) For “Moderator/Projector Remote/Template Password”, input the new password into both the
“New password” and “Reinput Password” boxes.
The number of characters, allowable characters, and password strength indicator are the
same as those for Admin Password.
5.
To apply the new password, click the [Save changes] button.
C