User Manual
Table Of Contents
- Contents
- Establishing a Network Connection Between the Projector and a Computer
- Establishing a Direct Wireless LAN Connection Between a Computer and the Projector
- Using a Wired LAN Connection to Connect the Projector to an Existing Network
- Connecting the Projector to an Existing Wireless LAN Access Point
- Using the Projector as a NAT Router (Simultaneous Use of Wireless LAN and Wired LAN)
- Using the Remote Controller to Configure Projector Network Settings
- Using a Computer to Configure Projector Network Settings
- Preparing for C-Connection
- Network Projecting a Computer Screen Image (Using C-Connection)
- C-Connection Details
- Advanced Operations
- Controlling the Projector from an External Network Device
- Ports Used for TCP/UDP
12
To display the projector’s wireless LAN information screen
Projector Operation
1.
Press the [MENU] key to display the setup menu.
2.
Select the following in sequence: “Network Settings” 3 “Wireless LAN Info”.
Next, press the [ENTER] key.
This displays the Wireless LAN Info screen.
The information that appears on the screen is explained below.
This item: Shows this:
Projector name This projector’s name (page 30)
MAC Address MAC address (physical address) of the wireless adapter connected to this
projector.
Operation Mode “Access Point Mode” (page 24) or “Client Mode” (page 25) is shown when this
projector’s “Enable Wireless LAN” check box (page 24) is selected. When the
“Enable Wireless LAN” check box is not selected, “Disable” is shown.
IP Address When “Access Point Mode” is selected, this item shows this projector’s LAN2 IP
address. When “Client Mode” is selected, this item shows this projector’s LAN1
IP address.
For information about the LAN1 IP address and LAN2 IP address, see “Network
Settings” (page 27).
SSID Access Point Mode display item. It shows this projector’s SSID.
Security Access Point Mode display item. It shows this projector’s security setting status
(page 25).
Subnet Mask Client Mode display item. It shows the Subnet mask (page 28) specified by the
Client Mode.
Default Gateway Client Mode display item. It shows the Default gateway (page 28) specified by the
Client Mode.
B