Hardware manual

The pin layout below shows when the terminal is viewed at the

1 2 3 4 5 6 7 8

Figure 2.1 Pin layout

Table 2.2 Pin assignment table

No.

Name Function Direction Remarks

1 GND GND -

2 USB_ID To switch USB to Host or Client. OUT Output from Cradle

3 V CRADLE Recharge/Power Supply to The

Terminal.

4 D+ USB D+ IN/OUT

5 D- USB D- IN/OUT

6 V CRADLE Recharge/Power Supply to The

Terminal.

7 NONE

8 GND GND -

Figure 2.2 Switch layout

Table 2.3 Switch assignment table

No. Initial switch state Function Remarks

1 ON Setting change disabled

2 ON Setting change disabled

3 ON Setting change disabled

4 ON Setting change disabled

5 ON Setting change disabled

6 OFF Setting change disabled

7 OFF Operation mode switch

8 OFF Setting change disabled

OFF