User Manual

E-112
Advanced programmings and registrations
 Other clerk settings
Step Operation
1 Turn the Mode switch to PGM position and select [System
Setting] then press F key.
>
▪▪▪▪▪
>
F
2 Enter 3 and press s key to set the register in the pro-
gramming mode.
3s
3 Enter 2 -digit clerk number followed by 07. The “07” is the
identication code for further program of clerks. Then press
s key. The example on the right is for programming to
clerk number 10.
1007s
(Clerk no.)
4 Referring the following tables, input the set code you wish
to program and press s key. The example on the right is
for setting a commission rate.
68s
(set code)
5 Enter the program code and press F key. The ex-
ample on the right is for setting 8.5% to commission rate 1
and 5% to commission 2.
08500500F
(program code)
6 If you wish to set the same program to the next clerk
number, perform the step 5 again. When you set to another
clerk (not next clerk number), repeat steps 3 through 5.
7 Press s key to complete the settings.
s
Set code 67 (Training mode)
Description Selection Program code
Training mode No = 0
Yes = 1
B
D6
Must be “00000”
ºººº
D5 D4 D3 D2
Registration operable Yes = 0
No = 1
B
D1
Example 1: To set the clerk number 15 as a clerk being trained.
Press 3s1507s100000Fs
Set code 68 (Commission rates)
Description Selection Program code
Commission rate 1 (integer) 00 to 99
BB
D8 D7
Commission rate 1 (decimal) 00 to 99
BB
D6 D5
Commission rate 2 (integer) 00 to 99
BB
D4 D3
Commission rate 2 (decimal) 00 to 99
BB
D2 D1