Specifications

— 17 —
LSI MON
SWO
LSO
" L "
" H "
GND
VDD
CSB
" H "
FROM CPU
CS2 terminal
(Pin 28)
(Pin 23)
(Pin 24)
(Pin 40)
(Pin 39) (Pin 17)
(Pin 22)
TO CPU
TO MAIN SWITCH
"L"
"H"
OFF
ON
SWO
SW
CPU
GATE ARRAY
MAIN SWITCH
VDD
"L"
"L"
KAC
KIO
(Pin36)
(Pin40)
(Pin54)
(Pin53)
POWER ON SWITCH
µPD65005G-452-22
GATE ARRAY
µPD65005G-452-22
(Pin 25)
(Pin 70)
INT0 terminal
µPD3055GF002-2BA
When VDD is applied from power supply IC
SC371015FU to gate array uPD65005G-452-
22, gate array will send "L" signal to active the
main switch signal from terminal SWO. Also,
gate array will send "H" signal to release the
INT0 terminal of CPU from LSO terminal.
The terminal CSB is for the chip select of gate
array. This signal is sent from CPU terminal
CS2. And when the VDD is applied to CPU,
CPU will send "H" signal to CSB terminal.
3) Main switch and power on switch
When the main switch is set to on position, SW terminal of CPU becomes "L", then CPU will send
"L" signal to KAC terminal to enable the system power on. The KI0 terminal is "H" when VDD is
applied to CPU. Therefore, when pressing the power on switch, CPU will generate a clock pulse (2
MHz) for start up the system.
GND
Open
2) Gate array