User manual - Screen Receiver

– 26 –
メッセージ 意 味 対処方法
The image could not be sent
from the calculator.
(1) Try pressing a key on the
calculator.
(2) Check to make sure that
the calculator is in the
Screen Receiver Mode.
If the screen is not sent after
you perform the above steps,
disconnect the USB cable and
check the calculator setup.
Next, reconnect and try again.
For details, select the
following on the menu bar:
Help - Manual, or refer to the
Screen Receiver user's guide.
電卓の画面を受信できない。 画面に出ている対処方法をお試
しください。
詳しくは
“3. Screen Receiver の使い
方”を参照してください。
The connection has been
broken for some reason and is
being restored.
If data communication does
not resume after some
time, perform the operation
described below.
Try pressing a key on the
calculator. If the screen is
not sent after you perform
the above steps, disconnect
the USB cable and check
the calculator setup. Next,
reconnect and try again.
For details, select the
following on the menu bar:
Help - Manual, or refer to the
Screen Receiver user's guide.
̶
画面に出ている対処方法をお試
しください。
The application is already
running.
Another user may already be
using the application.
他のユーザーがScreen
Receiver を起動している。
他のユーザーが実行している
Screen Receiver を 終了して
から実行してください。
* Mac OS：Macintosh