User manual

Cypher Technology Ltd 2008

3 Quick Start Guide

3.1 Turning On

1. Connect the supplied 12V 5A power supply (PSU) lead to rear panel power inlet and

screw up the connector. Connect the PSU to a mains supply using the supplied

cable.

2. Remove any Flash card.

3. Switch on the Power Switch on the rear panel (switch up). The display panel will

light up and show “Press I/O”. The green front panel LED will flash.

4. Press the I/O (On/Off) switch below the green Flashing LED. “On..” will be displayed

and the green LED will be on constantly.

5. After a few seconds, a growing line of dots will appear on the display and the system

will be ready for use after about 20 seconds.

3.2 Transferring Flash Card Data

1. Check that the displayed time and date are correct.

2. Insert the Flash card into the appropriate front panel slot. The display will show the

card’s size and number of files. A USB stick may be plugged into the rear panel.

3. Press the Disk button to open the DVD/CD draw. Place a DVD/CD in the tray and

press the Disk button once more to close the tray.

4. Press the TRANSFER button to start the transfer.

a) A Master copy is produced first. This consists of the transfer of the data from the

card to the disk and a verification read of the disk image file and the card. On

successful completion the Master disk will be ejected and the checksum of the Flash

card will be shown. This can be noted down for future reference. (where multiple disks are

produced, there are separate disk checksums also).

b) Remove the Master Copy disk and place a new DVD on the tray. Press the lower

soft key Marked “Continue” to proceed. The Working copy is now produced. On

successful completion the disk will be automatically ejected.

c) The Flash card may now be wiped and re-formatted. Press “N” when prompted if

this is NOT required.

The Transfer is complete.

Note: If further copies are required, do not wipe the card, and use the appropriate

functions available in the “Menu”. Press “Menu” soft key and the Up/Down cursor keys.

3.3 Turning Off

Press the I/O button below the green LED to shutdown. When “Switch Off” is displayed,

turn off the rear panel Power Switch.