Specifications

— 9 —
1-4. Current consumption
Set QV-5000SX to “PLAY” mode.
(1) Current consumption (DC in = 6.0 ± 0.1 [V])
(2) Lower the voltage from 6 V as shown below then make sure the battery warning indicator changes.
DC in = 5.0 ± 0.05 [V] (PLAY mode)
DC in = 4.65 ± 0.05 [V] (PLAY mode)
Note: Make sure that current consumption is less than 550 mA in PLAY mode.
Reference: • Current consumption of REC mode.
• Maximum 800 mA (Flash charge current is not included)
1-5. Operation check (Reference)
(1) Shock resistance, battery operation
(2) Jack operation, slide switch operation, button operation.
(3) Cover open/close operation, battery cover open/close operation
(4) Resolution, paralax, color revival
(5) Standard/Macro switch, AE operation, AF operation, self timer countdown display
(6) Flash display function, LED display function
(7) Video output, digital communication, page display
(8) Dust and scratches on lens
(9) Appearance
Notes: • In MACRO mode make sure the focus gets clear at a distance of 100 ± 4 mm from the front
part of protector.
• In NORMAL mode make sure you are able to see the specified resolution specified on the
center resolution chart and 79 % chart at a distance of 300 ± 10 mm.
• Operate the procedures listed below as a secondary judgement of procedure (2).
• In NORMAL mode make sure you are able to see the specified resolution specified on the
center resolution chart and 85 % chart at a distance of 1000 ± 10 mm.
* Take a shot at F mode then check the resolution after loading it to the PC.
* After checking on the PC. Adjustments are made only when there is a problem.
• Plates, letters, screws, label are to be checked as appearance.
• Check the color revival using tint chart and the noise level
Make sure the figures on video outputs are as shown below.
~ROM98022502: 1.0 V ± 0.2V (test pattern white100 %)
ROM98022601~: 0.82V ± 0.2V (test pattern white 75 %)
* Operate at 75 Ω end terminal.
• Make sure the setting “NTSC/PAL” after D-PCB replacement.