Specifications

— 22 —
3-6. Assist light adjustment.
1. General
Perform this adjustment when you replace the assist light(LED).
2. Necessary equipment
(1) Dark room.
(2) AC adaptor.
(3) TV (With video terminal).
(4) Video cable.
3. Condition
(1) Perform the adjustment in a dark room.
(2) Distance between Lens and object is 2.0 ± 0.1m.
(3) The camera's upper case is removed.
4. Adjustment.
(1) Connect AC adaptor and video cable to the camera.
(2) Turn on the camera and enter REC mode.
(3) Set the drive mode dial in AEB mode.
(4) Move the control button UP, UP, DOWN, DOWN.
(5) Assist light (LED) comes on.
(6) To move the assist light reflected on the screen to the correct position,
turn the screw A and B as shown below.
*Make adjustment while looking at the TV monitor.
5. Screw A and B.
(1) To move the assist light to the right and left,
turn the screw A.
(2) To move the assist light up and down,
turn the screw B.
6. Adjustment process.
Assist light
reflected on the screen.
LED plate Figure
<Before adjustment>
Screw A
<After adjustment>
Screw B
Focus range
reflected on the screen.
Both are matched.