Electronic Keyboard User Manual

English
Recording Your Keyboard Play
E-39
Deleting a Particular Track
1. Perform steps 1 through 3 of the procedure
under “Deleting a Recorder Song” to select
the recorder song that contains the track you
want to delete.
2. Press the
do
(i) button.
This displays the track selection screen.
3. Use the
ct
(w, q) buttons to select the
track you want to delete.
4. Hold down the
4
(SONG RECORDER)
button until the message “Sure?” appears on
the display.
5. Press the
ct
(YES) button to delete the track.
• To cancel the delete operation, press the
ct
(NO)
button.
You can use punch-in recording to re-record a specific
part of recorder song that you want to improve or
correct.
1. Enter the Song Recorder record mode and
select the track that contains the section you
want to re-record.
• See step 3 under “Recording to a Specific Track
(Part)” (page E-37).
2. Hold down the
4
(SONG RECORDER)
button until the punch-in recording screen
appears on the display.
3. Press the
bs
(START/STOP) button.
This will start playback of the selected track.
4. When playback reaches the point you want to
re-record, play the notes and perform the
other operations you want.
This automatically starts punch-in recording, which
will continue until step 5, below.
• Any one of the following also will start punch-in
recording: a pedal or pitch bend wheel operation;
pressing the
4
(SONG RECORDER) button;
*1
changing the tone setting; changing the rhythm, or
tempo setting
*2
• You can perform
bp
(REW),
bq
(FF), and
br
(PAUSE)
button operations during punch-in playback to jump
more quickly to the section you want to re-record.
5. To stop punch-in recording, press the
bs
(START/STOP) button again.
Anything in the track following the point where you
pressed the
bs
(START/STOP) button will be retained
as-is.
• If you want to delete all of the data in the track
following the section you re-recorded with punch-in
recording, press the
4
(SONG RECORDER) button
in place of the
bs
(START/STOP) button above.
• If you want to cancel punch-in recording and retain
the original (unedited) track data, hold down the
4
(SONG RECORDER) button until the display exits
the punch-in recording screen.
Re-recording Part of a
Recorder Song
(Punch-in Recording)
Mistake
Playback
Use punch-in
recording to re-record
only this part.
*1 Press
4
(SONG RECORDER) when you want to
start punch-in recording without note input or a
setting change.
*2
System track only