Electronic Keyboard User Manual

E-38
Recording Your Keyboard Play
4. Select the tone of the part you want to record
to the track.
5. Press the
bs
(START/STOP) button.
This will start playback of what you recorded to the
system track and start recording to the currently
selected track. Play what you want to record to the
current track along with the playback from the system
track.
6. To stop recording, press the
bs
(START/
STOP) button again.
This enters the playback mode. Press the
bs
(START/
STOP) button again to play back the track you just
recorded. Each press of
bs
(START/STOP) starts and
stops playback.
• You can use the following procedure to turn specific
tracks on (play enabled) and off (play disabled). This
allows you to listen only to the track(s) you want
when recording a new track.
7. Repeat steps 2 through 6 as required to
record all of the tracks you want.
Performance data recorded with the Song Recorder can
be deleted song-by-song. You also can delete a
particular track from a song.
Deleting a Recorder Song
1. Use the
4
(SONG RECORDER) button to
cycle through the Song Recorder modes until
the lamp above the SONG RECORDER
button is lit. This is the Song Recorder
playback mode.
2. While holding down the
cs
(FUNCTION)
button, press the
4
(SONG RECORDER)
button.
This displays the recorder song selection screen.
3. Use the
ct
(w, q) buttons to select the
recorder song you want to delete.
4. Hold down the
4
(SONG RECORDER)
button until the message “Sure?” appears on
the display.
5. Press the
ct
(YES) button to delete the
recorder song.
• To cancel the delete operation, press the
ct
(NO)
button.
(1) While holding down the
cs
(FUNCTION)
button, press the
4
(SONG RECORDER)
button.
This displays the song selection screen.
(2) Press the
do
(i) button once.
This displays the track on/off screen.
(3) Use the
ct
(w, q) buttons to select the track
you want, and then press the
dp
(ENTER) button
to toggle it on or off.
Deleting Data Recorded with
the Song Recorder
Lit: Playback mode