User Manual

Getting Ready
EN-51
3-2. If you plan to locate the piano and stand
against a wall, loosen the two screws (one on
the outside of each side panel) that secure
the brackets. You do not need to remove the
screws in this case.
• In this case, you do not need to remove the screws.
Just loosen them.
4. Insert angle brackets  into the gap between
the anti-tipping bracket and the side panel.
5. From the outside of side panels

and

,
temporarily tighten the screws you loosened
in step 3, above.
6. Place the two ends of the pedal unit  onto
the
 brackets and secure them with 
screws. Finish with
 screw caps.
7. While pressing the pedal unit down towards
the floor, securely tighten the screws you
partially tightened in step 5.
I
E
G
J
G
J