User Manual

EN-52

Getting Ready

(PX-870 only)

Secure the back panel



to the back board



• Place the back panel



onto pedal unit



so it is in

front of the three screw lugs of the pedal unit.

• Screw the screws



into the five holes in the back

panel



• Go around to the front of the Digital Piano and

securely tighten the three screws



shown in the

illustration below.

From the back of the assembled stand, slide

the piano into the grooves of side panel



and side panel



• Note that there is nothing anchoring the piano to the

stand at this time. Take care to ensure that the piano

does not fall off the stand.

10.

Use



screws to secure the piano to the

stand from both the front and the back.

[Front]

[Rear]