User Manual

EN-50
Getting Ready
1. Remove the four screws (two on each end)
from back board

.
2. Attach side panels

and

to back board
. Secure side panels

and

to the back
board

using the screws you removed in
step 1.
IMPORTANT!
• Attach the side panels so the side of the back board

where the joint connectors are inserted is facing
towards the back of the stand.
•If you have trouble inserting a screw into a joint
connector screw hole, use a screwdriver to adjust
the joint connector by rotating it.
3-1. If you plan to locate the piano and stand
where it is not against a wall, you need to
extend the anti-tip brackets at the base of
side panels

and

. Remove the two
screws (one on the outside of each side
panel) that hold the brackets, and then slide
the brackets as shown in the illustration. After
extending the anti-tip brackets, reinstall the
screws that secure them in place, but do not
tighten the screws fully at this time.
[Inside of side panels]
PX-870
• Make sure that the edge of back board  that has
the line of screw holes is facing downwards.
C
C
A
B
Screw holes
CC
AB
IMPORTANT!
Joint connectors
• When inserting a screw into a
joint connector, keep your
finger on the joint connector
hole on the back of back board

to make sure the joint
connector does not come out
of the hole.