Operation Manual

ManualsBrandsCasio ManualsMusical InstrumentPL-40R

A-17

Appendix

Parameter List

426-E-109A

PL40NE01-1.book 17 ページ２００２年７月２３日　火曜日　午後６時５２分

Summary of content (32 pages)

PAGE 1
PL40NE01-1.
PAGE 2
PL40NE01-1.
PAGE 3
PL40NE01-1.
PAGE 4
PL40NE01-1.
PAGE 5
PL40NE01-1.
PAGE 6
PL40NE01-1.book 22 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format J Note On MIDI Data Format Channel Messages Recognition Format The channel numbers used for channel messages received for each part are in accordance with the receive channel settings for each part made using the instrument’s “MIDI Rx Ch” parameter. Channel messages are not received for parts that are turned off using “MIDI Rx Ch”.
PAGE 7
PL40NE01-1.book 23 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format J Data Entry Control Change Format J Bank Select Format Byte 1 Byte 2 Byte 3 BnH 00H mmH (Bank Select MSB) BnH 20H llH (Bank Select LSB) Byte 1 Byte 2 Byte 3 BnH 06H mmH (Data Entry MSB) BnH 26H llH (Data Entry LSB) n..........Voice Channel Number = 0H to FH (Ch1 to Ch16) n..........Voice Channel Number = 0H to FH (Ch1 to Ch16) mm .....Bank Number MSB = 00H to 7FH ll..........Bank Number LSB = 00H to 7FH mm .....
PAGE 8
PL40NE01-1.book 24 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format J Expression Controller J Sostenuto Format Format Byte 1 Byte 2 Byte 3 Byte 1 Byte 2 Byte 3 BnH 0BH vvH BnH 42H vvH n..........Voice Channel Number = 0H to FH (Ch1 to Ch16) vv........Expression = 00H to 7FH Recognition n..........Voice Channel Number = 0H to FH (Ch1 to Ch16) vv........Sostenuto = 00H to 7FH (00H to 3FH : OFF, 40H to 7FH : ON) Send This message cannot be sent. Send J Hold 1 (Damper Pedal) n..........
PAGE 9
PL40NE01-1.book 25 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format J Sound Controller 3 (Release Time) J Effect 1 (Reverb Send Level) Format Format Byte 1 Byte 2 Byte 3 Byte 1 Byte 2 Byte 3 BnH 48H vvH BnH 5BH vvH n..........Voice Channel Number = 0H to FH (Ch1 to Ch16) n..........Voice Channel Number = 0H to FH (Ch1 to Ch16) vv........AMP Release Time = 00H to 7FH vv........Reverb Send Level = 00H to 7FH Send This message cannot be sent.
PAGE 10
PL40NE01-1.book 26 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format J NRPN (Non-Registered Parameter Numbers) With the instrument, NRPN are defined as tone editing parameters. The MSB and LSB of an NRPN specify the parameter being controlled, while the specified parameter’s value is set in accordance with the subsequent data entry. The following table shows the relationship between parameters and NRPN as defined by the instrument.
PAGE 11
PL40NE01-1.book 27 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format Filter Cut Off Frequency Filter/AMP Envelope Decay Time NRPN MSB = 01H NRPN LSB = 20H Data Entry MSB = mmH NRPN MSB = 01H NRPN LSB = 64H Data Entry MSB = mmH mm .....Cut Off Frequency = 00H to 40H to 7FH (–64 to 0 to +63) mm .....
PAGE 12
PL40NE01-1.book 28 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format J RPN (Registered Parameter Numbers) On the instrument, RPNs are defined as settings for the following parameters. NRPN MSB NRPN LSB 00H 00H Pitch Bend Sensitivity 00H 01H Master Fine Tuning 00H 02H Master Coarse Tuning 7FH 7FH RPN Null Parameter The MSB and LSB of an RPN specify the parameter being controlled, while the specified parameter’s value is set in accordance with the MSB of the subsequent data entry.
PAGE 13
PL40NE01-1.book 29 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format Program Change Pitch Bend Change Format Format Byte 1 Byte 2 Byte 1 Byte 2 Byte 3 CnH ppH EnH llH mmH pp .......Program Number = 00H to 7FH Recognition When a Bank Select MSB value other than 00H is received by the drum part at the same time as the program change message, that value is ignored and program change is performed as if the value were 00H.
PAGE 14
PL40NE01-1.book 30 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format J Reset All Controller J All Note Off Format Format Byte 1 Byte 2 Byte 3 Byte 1 Byte 2 Byte 3 BnH 79H 00H BnH 7BH 00H n..........Voice Channel Number = 0H to FH (Ch1 to Ch16) Recognition Receipt of the Reset All Controller message causes the following controllers to be reset. Controller Name Reset Value n..........
PAGE 15
PL40NE01-1.book 31 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format J Mono Mode On System Messages Format Byte 1 Byte 2 Byte 3 BnH 7EH vvH n..........Voice Channel Number = 0H to FH (Ch1 to Ch16) vv........Number of Mono Mode Channels = 00H to 10H System Real Time Message J Active Sensing Format Recognition Receipt of a Mono Mode On message does not turn on the instrument Mono Mode. Receipt of a Mono Mode On message is treated as an All Sound Off message.
PAGE 16
PL40NE01-1.book 32 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format J Stop J Chorus Parameters (Chorus Type Setting) Format Format F0 7F 7F 04 05 01 01 01 01 02 pp vv F7 Byte 1 FCH Recognition This message cannot be received. Send This message is sent when auto accompaniment and song playback ends while the instrument’s “Real Time Message Out” is turned on. System Common Message The instrument does not sends/recognizes System Common messages.
PAGE 17
PL40NE01-1.book 33 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format System Exclusive Message F0 44 7E 02 00 [SysExDevID] 40 20 05 0D 00 00 2F 00 00 00 00 il ih 04 00 pp 07 vl vh F7 [SysExDevID] : System Exclusive Device ID : 00H to 1FH, 7FH The system exclusive device ID is used to identify devices. A message is ignored if the device ID being sent does not match the ID of the receiving device. 7FH is a universal device ID, and messages with this ID are accepted unconditionally by all devices.
PAGE 18
PL40NE01-1.book 34 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format J DSP Reverb Send Level F0 44 7E 02 00 10 40 20 05 0D 00 00 2F 00 00 00 00 06 00 04 00 00 07 vl 00 F7 vl = 0 to 7F : Send This message is sent when a function switch operation or other DSP reverb send level setting operation is performed. Receive Receipt of this message changes the DSP reverb send level setting.
PAGE 19
PL40NE01-1.book 35 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format J Stretch Tune (Tune Function) F0 44 7E 02 00 10 40 20 05 0D 00 00 2F 00 00 00 00 00 00 04 00 00 07 vl 00 F7 vl = 00H : Off vl = 01H : On Send This message is sent when a function switch operation or other stretch tune setting operation is performed. Receive Receipt of this message changes the stretch tune setting.
PAGE 20
PL40NE01-1.book 36 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format J Reverb Level F0 44 7E 02 00 10 40 20 01 00 00 00 2F 00 00 00 00 03 00 08 00 00 00 07 vl 00 F7 This message sets the reverb tone return (output) level. value level 00H 0 (%) 40H 100 (%) 7FH 200 (%) Send This message is sent when a reverb switch or other reverb level setting operation is performed. Receive Receipt of this message changes the reverb level setting.
PAGE 21
PL40NE01-1.
PAGE 22
PL40NE01-1.book 38 ページ２００２年７月２３日火曜日午後６時５２分 MIDI Data Format J Channel After Touch Dependent Lfo2 Frequency Variation Setting F0 44 7E 02 00 10 40 20 01 00 00 00 2F 00 00 00 00 4E 00 08 00 00 pp 07 vl 00 F7 pp = Part : 0 to 1F (Group A : 00H – 0FH , Group B : 10H – 1FH) Range vl = 00H : –10.0 (Hz) vl = 40H : 0.0 (Hz) vl = 7FH : +10.
PAGE 23
PL40NE01-1.
PAGE 24
PL40NE01-1.book 40 ページ２００２年７月２３日火曜日午後６時５２分 Index 3-Step Lesson ............................................................ E-40 Accomp MIDI Out ................................................... E-68 Advanced Lesson System ......................... E-35, E-39 Arrangement Levels ................................................ E-39 Auto Harmonize ...................................................... E-29 Banks .......................................................................... E-50 Break ..
PAGE 25
PL40NE01-1.
PAGE 26
PL40NE01-1.
PAGE 27
PL40NE01-1.
PAGE 28
PL40NE01-1.
PAGE 29
PL40NE01-1.
PAGE 30
PL40NE01-1.
PAGE 31
PL40NE01-1.
PAGE 32
PL40NE01-1.