Instruction manual

13
Getting Started
Programming automatic tax calculation
This cash register is capable of automatically calculating up to three different sales taxes. The sales tax calculations
are based on rates, so you must tell the cash register the rates, the type of tax (add-in or add-on), and the type of
rounding to apply. Note that special rounding methods (page 14) are also available to meet certain local tax requirements.
Important!
After you program the tax calculations, you also have to individually specify which departments
(page 28) and PLUs (page 30) are to be taxed.
Programming tax calculations (without special rounding)
Prepare the following subjects:
1. Tax rates
2. Rounding method for tax calculation (Round up/Round off/Cut off)
3. Tax calculation system (Add-on/Add-in)
Programming procedure
Assign Tax Table 1.


Enter tax rate
(2 integer and 4 decimal).



Enter rounding method, tax calculation method.






Terminate the procedure.
6
6
6
6
4
3s
4
0125s
4
::::::a
4
0a
4
::::a
4
s
Assigning Tax Table 2, enter 0225.
Assigning Tax Table 3, enter 0325.


Example: 15% = 15
8.25% = 8^25
Add-on tax
Fraction round up = 9002
Fraction round off = 5002
Fraction cut off = 0002
Add-in tax
Fraction round up = 9003
Fraction round off = 5003
Fraction cut off = 0003

PGM
A-A08
Mode Switch
X
Z
CAL
REG
OFF
RF
PGM
11. Tax table programming