User manual

ManualsBrandsCasio ManualsFitness TrackersOceanus OCW-S5000F

Table Of Contents

Contents

Before Getting Started...

Watch Face Items

Navigating Between Modes

Mode Overview

Using the Crown

Hand and Day Indicator Movement

Solar Charging

Useful Features

Time Adjustment

Time Adjustment Using a Time Signal

Overview

Appropriate Signal Reception Location

Time Calibration Signal Reception

Ranges

Auto Time Calibration Signal Receive

Manual Time Signal Receive

Signal Reception Precautions

Using Watch Operations to Adjust the Time

Setting

Setting a Home City

Adjusting the Time and Day Setting

Configuring the Summer Time Setting

(Home City)

Checking the Last Time Adjustment Result

Using the Watch in a Medical Facility or

Aircraft

MA2207-EF

Using Mobile Link with a Mobile

Phone

Getting Ready

Install the required app on your phone.

Configure Bluetooth settings.

Pair the watch with a phone.

Auto Time Adjustment

Configuring World Time Settings

Adjusting Hand and Day Indicator Alignment

Phone Finder

Configuring Watch Settings

Changing the Home City Summer Time Setting

Checking the Watch Charge Level

Connection

Connecting with a Phone

Canceling a Connection with a Phone

Using the Watch in a Medical Facility or

Aircraft

Unpairing

If you purchase another phone

World Time

World Time City Setting

Configuring the Summer Time Setting (World

Time)

Swapping Your Home City Time and World

Time

Stopwatch

Measuring Elapsed Time

Adjusting Hand and Day Indicator

Alignment

Adjusting Hand and Day Indicator Alignment

Moving to Another Time Zone

Other Information

City (Time Zone) List

Summer Time Table

Supported Phones

Specifications

Mobile Link Precautions

Copyrights and Registered Copyrights

Troubleshooting

Operation Guide 5603

Summary of content (21 pages)

PAGE 1
MA2207-EF © 2019 CASIO COMPUTER CO., LTD. Operation Guide 5603 Contents Before Getting Started... Watch Face Items Navigating Between Modes Using Mobile Link with a Mobile Phone Getting Ready City (Time Zone) List B Configure Bluetooth settings. Summer Time Table C Pair the watch with a phone.
PAGE 2
Operation Guide 5603 Before Getting Started... This section provides an overview of the watch and introduces convenient ways it can be used. Pushing the crown back in after pulling it out will cause the mode hand to indicate the current charge level. While a Stopwatch Mode elapsed time measurement operation is being performed, the mode hand points to [ST]. The illustrations included in this operation guide have been created to facilitate explanation.
PAGE 3
Operation Guide 5603 ● Stopwatch Mode ● Common Operations in All Modes The second hand, and the small hour and minute hands indicate the elapsed stopwatch time. ● World Time Mode ● Fast Forward/Fast Reverse Stopwatch Mode The main hour and minute hands indicate the current time. 30 ① ②③ ④ 30 Start/ Stop After pulling out the crown to the first or second click, rotating it quickly in succession in either direction will start a fast forward or fast reverse operation.
PAGE 4
Operation Guide 5603 Solar Charging This watch runs on power supplied from a rechargeable (secondary) battery that is charged by a solar panel. The solar panel is integrated into the face of the watch, and power is generated whenever the face is exposed to light. ● Checking the Charge Level Dead Battery Pushing the crown back in after pulling it out will cause the mode hand to indicate the current charge level. After a short while, the mode hand will indicate the current day of the week.
PAGE 5
Operation Guide 5603 ● Power Saving Leaving the watch in a dark location for about one hour between the hours of 10 p.m. and 5:50 a.m. will cause the second hand to stop, and the watch to enter Level 1 power saving. If the watch is left in this condition for six or seven days, all hands will stop and the watch will enter Level 2 power saving. Useful Features Pairing the watch with your phone makes a number of the watch’s features easier to use.
PAGE 6
Operation Guide 5603 Time Adjustment Using a Time Signal Overview The watch’s time and day settings can be configured in accordance with a received time calibration signal. Important! ● ● ● ● A time calibration signal can be received while the watch is near a window. ● ● Position the watch so its 12 o’clock side is facing the window. Keep metal objects away from the watch. ● Do not move the watch. ● Do not perform any operation on the watch.
PAGE 7
Operation Guide 5603 Auto Time Calibration Signal Receive Note An automatic time calibration signal receive operation is performed and the time and day settings are adjusted between midnight and 5:00 a.m. Once a signal receive operation is successful, no more auto receive operations are performed that day. ● ● Getting Ready ● Enter the World Time Mode or the Stopwatch Mode with the stopwatch reset to all zeros.
PAGE 8
Operation Guide 5603 5. Rotate the crown to move the second hand to the desired setting for the year ten’s digit. Year (10’s digit) 00 10 20 90 30 80 Configuring the Summer Time Setting (Home City) If you are in an area that observes summer time, you can also configure a summer time setting. 60 ● 50 6. Press (B). This enables the year one’s digit setting operation. 7. Rotate the crown to move the second hand to the desired setting for the year one’s digit.
PAGE 9
Operation Guide 5603 Using the Watch in a Medical Facility or Aircraft Whenever you are in a hospital, on an aircraft, or in any other location where auto time calibration signal receive or connection with a phone may cause problems, you can perform the procedure below to disable such operations. To re-enable auto time adjustment, perform the same operation again.
PAGE 10
Operation Guide 5603 Important! ● The watch may not be able to perform auto time adjustment under the conditions described below. ー While the watch is too far away from its paired phone ー While communication is not possible due to radio interference, etc. ー While the phone is updating its system ー While CASIO WATCHES is not running on the phone Configuring World Time Settings Specifying a World Time City with CASIO WATCHES causes the watch’s World Time City to change accordingly.
PAGE 11
Operation Guide 5603 ● Swapping Your World Time and Home Time 1. Y Tap the “CASIO WATCHES” icon. 2. X Hold down (B) until the second hand points to [C] twice. This establishes a connection between the watch and phone. ● The second hand will point to [C] once after about 0.5 seconds, and then a second time after about 2.5 seconds. Adjusting Hand and Day Indicator Alignment 2. X Hold down (B) until the second hand points to [C] three times.
PAGE 12
Operation Guide 5603 Changing the Home City Summer Time Setting 1. Y Tap the “CASIO WATCHES” icon. 2. X Hold down (B) until the second hand points to [C] twice. This establishes a connection between the watch and phone. ● The second hand will point to [C] once after about 0.5 seconds, and then a second time after about 2.5 seconds. Connection Connecting with a Phone This section explains how to establish a Bluetooth connection with a phone that is paired with the watch. ● 30 2.
PAGE 13
Operation Guide 5603 World Time Unpairing Unpairing the watch from a phone requires both CASIO WATCHES and watch operations. World Time lets you look up the current time in any one of 27 cities and 38 time zones around the globe. ● Deleting Pairing Information from CASIO WATCHES press any button to terminate the connection. ● 30 Disconnected 30 If you are in an area that observes summer time, you can also configure a summer time setting. Note 1.
PAGE 14
Operation Guide 5603 Swapping Your Home City Time and World Time In the World Time Mode, hold down (A) for about three seconds to swap your Home City time with your World Time. Before swapping Home Time Stopwatch Note The stopwatch measures elapsed time in units of one second up to 23 hours, 59 minutes, 59 seconds (24 hours).
PAGE 15
Operation Guide 5603 Adjusting Hand and Day Indicator Alignment 1. Pull out the crown to the second click. 2. Hold down (B) for at least six seconds until the second hand points to 12 o’clock twice. Release the button when the second hand reaches 12 o’clock. 5. If the small hour and minute hands, and the small 24-hour hand are not at 12 o’clock, rotate the crown to align them with 12 o’clock. 6. Press (B). Confirm that the mode hand is stopped at “Su”, and check if the day is indicated properly.
PAGE 16
Operation Guide 5603 Other Information ● After Arriving 1. Swap the origin time zone time with the destination time zone time. Before swapping After swapping This section provides non-operational information you also need to know. Refer to this information as required. Destination time City (Time Zone) List 30 30 2. Enable auto time adjustment. l Using CASIO WATCHES to Configure Settings Using Watch Operations to Configure l Settings 3. Adjust the time setting.
PAGE 17
Operation Guide 5603 Supported Phones For information about phones that can connect with the watch, visit the CASIO website. https://world.casio.com/os_mobile/wat/ Specifications Accuracy at normal temperature : ±15 seconds per month average when time adjustment by time calibration signal reception or by communication with a phone is not possible.
PAGE 18
Operation Guide 5603 Troubleshooting ● Stopping Radio Wave Emission by This Watch The watch is emitting radio waves whenever the second hand is pointing to [C]. Even if the second hand is not pointing at [C], the watch will automatically attempt to connect with a phone four times a day to adjust its time settings. When in a hospital, on an aircraft, or in any other area where the use of radio waves is not allowed, use the operation below to stop radio wave generation.
PAGE 19
Operation Guide 5603 I can’t pair the watch with a phone. I can’t reconnect the watch and phone. Q1 I’ve never been able to establish a Q1 The watch will not re-connect with the phone after they are disconnected. (pairing) connection between the watch and phone. Is CASIO WATCHES running? Are you using a supported phone model? Q3 I can’t establish a connection after disabling the watch’s auto time adjustment feature.
PAGE 20
Operation Guide 5603 Phone-Watch Connection Q1 I can’t establish a connection between the phone and watch. Have you tried turning your phone off and then back on again? Turn the phone off and then back on, and then tap the “CASIO WATCHES” icon. Next, on the watch, hold down (B) until the second hand points to [C] twice. ● The second hand will point to [C] once after about 0.5 seconds, and then a second time after about 2.5 seconds.
PAGE 21
Operation Guide 5603 Q6 Why is the current time indicated by the watch is off by a certain amount of time (nine hours, three hours and 15 minutes, etc.)? The city setting is not correct. Select the correct setting. l Setting a Home City Q7 The current time indicated by the watch is off by one hour or 30 minutes. The summer time setting is not correct. Select the correct setting. l Configuring the Summer Time Setting (Home City) Q8 The hand and/or day indicator are not aligned correctly.