User manual - TE_SmartClient_UsersManual

NAURTECH TERMINAL EMULATION & DATA COLLECTION WEB BROWSER FOR WINDOWS CE / WINDOWS MOBILE
CETerm | CE3270 | CE5250 | CEVT220 Page 34
Confirm Exit (Connected): Check this option if you want to be prompted prior to
exiting the application if one or more sessions are connected.
Exit on Disconnect: Check this option to exit the application when one or more
of the connected sessions disconnects. The disconnection may be triggered by
either the user or by the host.
Check Network on Connect: When enabled, the network signal presence will
be automatically checked when an attempt is made to connect / reconnect to the
host. The user will be prompted if the device is out of RF range or if the network
cannot be detected.
Check Network on Resume: On certain devices, depending on your
configuration settings, the OS withdraws power from the WLAN card when the
device is suspended. This may be done to prolong battery life. When enabled,
this setting ensures presence of a network signal when the device is resuming
itself from a “Suspend” state. The user will be prompted if the device is not
associated, is out of RF range or if the network cannot be detected.
Check Network before Send: For version 5.1, this setting in only applicable to
HTML browser sessions. It does not effect any of the terminal emulation
sessions. When enabled, the network signal presence and availability will be
checked every time before sending any data to the host server. The user will be
prompted if the device is out of RF range or if the network cannot be detected.
Term Type: Leave this blank unless required. If not empty, this value is reported
as the terminal type in the Telnet negotiations. Use this only if your host has a
special Telnet server that uses the value to identify devices or special situations.