User Manual

5
■ Enhanced volume adjustment function for Drawber Organ tones
■ Addition of a Percussion Mode for Drawber Organ tones
(Both MZ-X500 and MZ-X300)
The drawbar organ parameters shown below are added by this version.
• The Leakage Noise setting of Version 1.0X has been changed to the Running Noise setting for this version.
■ Addition of user samples to the Inst Select (instrument selection) of Drum tones
(Both MZ-X500 and MZ-X300)
This change makes it possible to use the Inst Select item on the drum sound editable tone parameter screen to
specify user samples loaded from a USB flash drive or recorded with the pad sampling function.
• Note that only user samples for which Short is specified as the Length can be specified for a drum sound.
■ Addition of a Group setting for pads
(Both MZ-X500 and MZ-X300)
This update adds a Group function that makes it possible to alternate multiple pads with the pad Setting Item.
Display Name Description Settings
Volume Controls drawbar organ overall volume. 0 to 127
Click Level Sets the click volume. 0 to 15
Percussion Mode Specifies how percussion is sounded.
Select “Mono” for monophonic sound, or “Poly” for polyphonic sound.
Mono, Poly
Noise >Enter This is a group of editable noise parameters.
Running Noise Specifies the volume of the tone wheel signal (Running Noise) that is
always being generated while nothing is being played.
0 to 15
Tone Wheel
Leakage
Specifies the volume of signal leakage from other tone wheels (Tone
Wheel Leakage Noise) while something is being played.
0 to 15
Drawbar Leakage Specifies the volume of signal leakage from drawbars (Drawbar Leakage
Noise) that are set to level 0.
0 to 15
Display Name Description Settings
Group Assigns a group number (1 to 8) to a pad.
Performing a pad operation while the operation of another pad with the
same group number is being performed causes the ongoing pad
operation to stop as the new pad operation is started.
Off, 1 to 8