User Manual
3
Performing the firmware update procedure incorrectly can result in you are not being able to start up your Digital
Keyboard. Be sure to observe the points below.
• Back up user data in Digital Keyboard memory to a USB flash drive before updating the Digital Keyboard
firmware.
• Do not disconnect the AC adaptor or remove the USB flash drive from the Digital Keyboard while firmware
updating is in progress.
• Do not touch any buttons or keyboard keys, except as required for updating, while firmware updating is in
progress.
Perform the steps below to update.
1.
Copy the “update.bin” firmware file to a USB flash drive.
• Use a USB flash drive that has been formatted to FAT32.
• Place the “update.bin” firmware file into the root (not a folder) of the USB flash drive.
2.
Insert the USB flash drive from step 1 of this procedure into the Digital Keyboard’s USB flash drive
port.
3.
On the MENU screen, touch “SYSTEM SETTING”.
4.
Next to “Information”, touch “Enter”.
5.
In the list that appears, touch “Execute” next to “Update Firmware”.
6.
In response to the “Sure? Yes/No” message that appears, touch “Yes”.
• Firmware updating takes about 30 minutes. Do not touch the Digital Keyboard during that period.
• A progress bar will appear on the display to show you the progress of the update.
• The Digital Keyboard will automatically restart after the update is complete.
7.
After the Digital Keyboard restarts, remove the USB flash drive.
This completes the firmware update operation.
If an error message appears and updating fails for some reason, perform the steps below to re-attempt updating.
1.
Unplug the AC adaptor from the Digital Keyboard.
2.
Correctly re-copy the “update.bin” update file to the USB flash drive.
3.
Make sure that the USB flash drive is inserted correctly into the Digital Keyboard’s USB port.
4.
Connect the AC adaptor to the Digital Keyboard.
5.
Press the Digital Keyboard’s power button to turn it on.
• If the update operation starts automatically, wait for about 30 minutes until updating is complete and the Digital
Keyboard restarts.
• If the Digital Keyboard restarts normally, go to the MENU screen, and touch “SYSTEM SETTING” and then
“Information”. Check the Digital Keyboard’s current firmware version. If it is not planned firmware Version, perform
steps 5, 6, and 7 of the update operation again.
• If updating is stopped by display of an error message, it could mean that there is something wrong with your
“update.bin” file and/or USB flash drive. Check for problems.
Updating Firmware